reinforcement bar

[97 kooki]

does any one happen to know if 240sx reinforcement bars are different as far as where it bolts to on the frame...  the bracket things i mean... because on my kouki those are messed up the bar my friend said is still good enough but the brackets on it are all bent up.... basically wondering if like the older 240sx reinforcement brackets bolt up the same  because there easier to find so was just going cut an weld them on to my reinforcement bar.... i know not the best  thing to do but lol but just looking for a cheap fix for now seeing as my stock one new is like 200 bucks ,,,, any help appreciated thanks

[niZmo]

blongi should know, he put the kouki front on his zenki.  ill let him know.

Richie

[97 kooki]

k well more or less i wanna know if the brackets from the s13 reinforcement bar will fit on my car.... because i know the zenki is the same but finding one an for cheap is kinda hard.... where as the s13 is pretty much everywhere....... just not trying to pay 200 bucks for a brand new one... tried finding a used one but have not had any luck...


im basically going to reuse my kouki reinforment bar but just looking to swap out the brackets because there all bent an cant be reused..  so wanted to see if i can use s13  brackets on it   ... but yea thanks

[witness]

Id have to check it out, Not sure what your talking about when you say "brackets"

your talking about those two brackets that go on your chassis beams? there held by two bolts and two nuts?

Ive tooken apart and s13 front end, as well as a complete silvia front.
On the Silvia bar it they had to extend the bar so the brackets would match up i would assume the s13 is not as wide as an s14 bar eyeballing it.


Im not sure if that helps sorry. If not let me know what your talking about.
 I remember how the s13 support looked i can check it out on my kouki tomorrow.

[niZmo]

if your trying 2 put s13 brackets on a s14, then i would say no. 2 totally different bumpers & bodies.

Richie

[witness]

your talking about this right?

[97 kooki]

yea those are what im talking bout sorry i didnt put a picture of it sitll dont know how to do that on here... but yea thats what im talking bout... what are they  called by the way? lol so i can stop calling them "brackets" ...... 

mainly just trying to see if the locations of where it bolts up are the same  regardles if u gotta cut an weld or length it.....  i know not rhe smartest thing to do lol but right now short on cash an just wanna low budget fix till i can afford to get something better...

[witness]

Yea there brackets, but i wasn't sure if i was on the same page as you.

That's ^^ a s13 bar are the brackets the same? I looked under my car today but couldn't see jack do to my skid plate, and im to lazy to take it off lol.

[b13turbo]

I think they are different, but there is a s14 in fresno off of Golden State Blvd. and Jesen on the hwy 99. 

[97 kooki]

lol o ok well thanks for the info... ill probably go to like pick in pool or something to look an see if they are the same... before i decide  to buy anything but yea jus looking to do a gettho cheap fix on it to atleast make the front a little better.... but yea thanks for the info

[s14kid]

Wont be needing the one on my zenki no more  . You can take it for $50 if you want it